|
Kody and I cut out these plates today. They will become bellcrank mechanisms for the
tipup popup modification I'm planning. After dropping Kody off at home, I decided to
finish them up.
|
|
After drilling a pilot hole in the top plate of the stack, I clamped the four plates
together while using a stub of tubing to center them all up. This will ensure the plates
are all identical.
|
|
All plates have been drilled through with a #12 bit.
|
|
With a bolt through the stack to keep everything aligned, it's time to work on
contouring the outside of these bellcranks.
|